5.4Ton Overhead Line Construction Tools Wire Rope Winch Lever
Pulley Block Manual Wire Rope Pulling Hoist
The body structure is novel:
This machine adopts high-strength aluminum alloy body, which is
beautiful in appearance, compact in body and light in weight. It
adopts two-stage gear transmission, and the high-speed stage is
helical gear transmission, so the transmission is stable.
High strength parts:
The main parts of the machine are made of high-grade alloy steel
material and processed by many special heat treatment processes. It
has the characteristics of high strength and good wear resistance.
The upper and lower hooks are made of high strength alloy steel and
have high toughness after strengthening heat treatment. Even if the
body is damaged due to overloading, the hooks will only produce
plastic deformation without brittle fracture.
|Model||GXSM-618 0.8||GXSM-618 1.0||GXSM-618 1.6||GXSM-618 3.2||GXSM-618 5.4|
|Rated load lifting capacity||ton||0.8||1||1.6||3.2||5.4|
|Stroke when the rated||mm||≥52||≥52||≥55||≥28||≥30|
|Forward handle effective length||mm||825||825||1200||1200||1200|
|Wire rope diameter||mm||8||8||11||16||20|
|Wire rope standard length||m||10, 20||10, 20||10, 20||10||10|
|Hand force when the rated||N||≤284||≤353||≤412||≤441||≤745|
Scope of application:
The wire rope handle hoist is suitable for operation in the narrow
area where the local space is limited.For field operations, aerial
work, lifting operations in the deep well operation of the GXSM-618
5.4 wire rope hand hoist and the inorganic electric energy supply
site will show special advantages.
The wire rope pulling hoist is obtained by the human lever wrench,
and the linear traction matched with the load is obtained by the
principle of the lever, and a caliper body acting on the movement
of the movement is alternately operated with a load.
How to use:
Put the forward (reverse) handle to the machine first, then push
the handle to the front of the machine, and the tip can be snapped
into the upper step of the housing.
At this time, the upper and lower clamps of the front and rear
calipers are OK.
The opening can be worn (pumped), and then the hand can be pushed
forward and downward to push the release handle, so that the clamp
clamping wire rope (or reset) can be put into operation.
- Forward and backward lever: Placed in series to provide a thin design to ensure power
transmission along the center.
- Spare shear pins: Two spare shear pins are locked in the handle.
- Rope clamp system: Easily disengaged with a lever allowing smooth installation of the