Carton Box Chain Feeding Rotary Die-Cutting Machine/corrugated box
Corrugated Paperboard Carton Box Chain Feeding Rotary Die-cutting
machine Is Also Called Corrugated Cardboard Carton Box Chain
Feeding Rotary Die-cutting machine
INSTALLATION AND ADJUSTMENT
1. Put machine main unit in flat cement floor, then use lever
instrument to measure flat, error not over 0.1‰, make complete
machine is flat.
2. Connect feeding table with main unit: Connect Left front under
chain wheel with gear of feeding shaft by chain, fix right front
with main unit by bolt. Then Fix left side control box and right
3. After finish all of prepare work, then connect electricity and
take no load running (Clean all of tools and junk). Check machine
flat or not, have noise or not, ensure normal then start work.
Install wooden mould:
Put the wooden die in anywhere, make M8*25 bolt to fix die on the
lower roller, the order from middle to both side, and then around
circumference, let die cling to the roller surface. When use two
dies, must attend connect place and let cutter edge is flat.
Connect air compressor:
Take air tube connect the air compressor with the FRL that under
the left side operation box, and open the pressure valve, send air
Start On Machine:
Connect power, press “M. unit ON” button, indicator light; then
press the bell to alarm safety; then press “air pump ON”, indicator
light, provide air to machine; Switch on speed controller, rotate
knob speed up, feeding sheets, turn the “lift roller” knob to
|Model||Roller diameter||Max Over Sheet Size||Min Over Sheet Size||Speed||Motor|
This machine consists of die-cutting part and sheet feeding part.
1. Die-cutting part: It main includes upper and lower die-cutting
roller and paper feeding roller. Adjust rod drive both side gears
rotating to adjust paper feeding roll, so that adjust sheet
thickness to prevent the sheet be damaged due to pressure.
2. Upper and lower roller is main roller to make and form carton
box. Upper roller is wired polyurethane rubber, lower roller mount
die. When machine is running, two rollers rotate make serrated
knife cut-cover rubber, and then cutting sheet. After some times,
the rubber is rough and rugged, affecting working quality, so need
3. This machine equipped with sand paper shaft to repair rubber,
after some times repairs then it is thin, to change new rubbers. To
improve use life, machine with axis movement in 40mm. The pressure
be provided by air compressor, then through cylinder send pressure
to make rollers running to cutting sheet
Q:What can you do if the machine broken?
A:Our machine's warranty period is 12months,if the broken parts
can't repair,we can send the new
parts replace the broken parts freell,but you need pay the express
cost yourself.if after warranty period,we can through
negotiationfor to solve the problems,and we supply the technical
support for the whole life of the equipment.
Q:What about the service after sale?
A: One you have bought our machine, you can call us or email us
telling us the machine problems and any questions about the
machines. We will reply to you with 12hours and help you to slove
Q: How to visit your company?
a.Fly to Beijing airport: By high speed train From Beijing Nan to
Cangzhou Xi (1 hour), then we can pick up you.
b.Fly to Shanghai Airport: By high speed train From Shanghai
Hongqiao to Cangzhou Xi(4.5 hours), then we can pick up you.
Q:You are trade company or factory?
A:We are trade company but we also have own factories. Building
trade company is just for exporting various types of packing
Q. How long the machine could be made?
A:Normally speaking, machine could be made within 45 working days.
If you need machines in a hurry, we can make it for you less than a