AC 120V / 60Hz UV Magnetic Washing Machine Water Filter for
Sterilization and Disinfection
PRODUCT INTRODUCTION & PRINCIPLE
ECO Mini Purifier contains no water storage, meaning to purify and
use water simultaneous, to avoid the second pollution due to
ECO Mini Purifier is an environmentally friendly appliance applied
in bathing, kitchen washing, pet sterilizing and so on. With the
efficiency of sterilizing, disinfecting and purifying water, ECO
Mini Purifier is aiming at reducing the damage resulted from the
bacteria which may be spread through water.
ECO Mini Purifier adopts advanced nanotechnology and permanent
magnetic material to soft the tap water, through mixing the water
in the static mixer for the first time, and then mixed with
controllable ozone and silver ions, through the second time in the
static mixer to make sure appropriate gas-liquid mixing proportion.
ECO Mini Purifier has the main functions as below:
Sterilization and disinfection;
Decontamination and purification;
Clean and softening;
Energy conservation and environmental protection
Smart & Low consumption
TECHNICAL SPECIFICATION TABLE
ECO Mini Purifier (OLK-P-01)
Input:AC120V∕60Hz Output:DC 12V 2.5A 30W
0.3~0.5 mg/ L
USE & SAFETY CONSIDERATION
Before using, please read the User’s Manual carefully.
Do not operate the unit with the cover removed.
Disconnect ALL power before servicing.
Do not mount the ECO Mini Purifier vertically or at an angle.
Do not use an extension cord or a different power adapter (other
than the one provided with your ECO Mini Purifier with this
Maximum water inlet pressure is 75psi.
Use the included new hose when connecting ECO Mini Purifier to the
Under residential use, the Silver Ion Probe installed in your ECO
Mini Purifier has a life expectancy of approximately one and a half
years. The red Service indictor lamp, seen through the window in
the front of your unit will be lighted when the Silver Ion Probe
requires replacement. The indicator lamp will glow blue when the
unit is operating properly and will turn red when the probe
Use a soft cloth dampened with water. Do not clean your ECO Mini
Purifier with harsh chemicals, abrasives or cleansers.
ECO Mini Purifier is designed for residential use only and is not
intended for use in a commercial or industrial setting.
ECO Mini Purifier can work normally in the temperature category
0℃~78℃, without components breakdown.
CONTROL PANEL DIAGRAM
Silver Ion Probe
Red Light indicates one part works abnormally.
1. ECO Mini Purifier will offer a metallic plate, a power adapter,
4-1/4 tapping screws, a hose, a wrench, and a screwdriver as
2. The ECO Mini Purifier should be fastened to the wall, left above
your tap. Firstly, fix the metallic plate on the wall. The metallic
plate has three mounting holes, together with 3 anchor screws.
Fasten the metallic plate on the wall with the anchor screws to
support the product.
3. Before installation, do not open the unit. There are 3 sockets
on the bottom of the unit.Collimate the 3 sockets in the holes of
the metallic plate, pull downward slowly, and then the unit is
hanging over the metallic plate.
4. Ensure that metallic plate is horizontal. Tilt installation may
affect the product operation and visualization.
5. Connect the water inlet on the ECO Mini Purifier to the water
supply faucet; and connect the water with the supplied hose. Make
sure rubber washers are properly installed in both ends of the hose
before connection. Properly tighten the hose to the inlet fitting,
but do not over tighten.
6. Plug the supplied power adaptor into the DC adaptor plug-in on
the side of the ECO Mini Purifier unit and then plug the adapter
into the wall outlet. Disconnect the power adapter when not use the
System Set Up
1.Turn on the water valve/faucet. Check the connections to ensure
that there is no leakage or dripping. Tighten the hose connections,
if necessary, but DO NOT over tight.
2.Connect power adapter, and then start your washer. Once the water
begins to flow, the blue light of the ECO Mini Purifier should
begin to glow.
There are two states of the LCD control panel screen.
Blue Light: work normally.
Red Light: work abnormally or break down.
If the unit works abnormally, please contact our Customer Service.
Alarm of Leakage
ECO Mini Purifier is equipped with a switch and an alarm against
leakage. If the leakage happens, the water will accumulate on the
bottom panel inside the unit. The sensor will set off an audible
alarm and will automatically turn the unit off. This alarm will
continue to buzz until the leak is stopped and/or the unit is
unplugged. If this alarm should occur, you should unplug the unit,
turn off the cold water valve and call our Customer Service team
Replacement of Silver Ion Probe
Under normal usage, the Silver Ion Probe installed in your ECO Mini
Purifier has a life expectancy of approximately one and ahalf
years. The on the control panel will turn RED when the Silver Ion
Probe requires replacement. Please contact our Customer Service
team to order a new Silver Ion Probe and replace it as the
1. Disconnect the power and take off the hoses connected to the
water inlet and water outlet.
2. Turn off the water supply valve / faucet.
3. Turn on the wash machine momentarily to relieve any internal
water pressure within the ECO Mini Purifier unit.
4. Turn off the washing machine and unplug the power adapter of the
ECO Mini Purifier.
5. Push the ECO Mini Purifier a little higher than the metallic
plate, and take it off from the metallic plate.
6. Find the 4 screws holes on the base, unscrew and press the
cover, you will see the Silver Ion Probe ( see the structure
7. Unscrew the Silver Ion Probe with the supplied wrench, and then
fix the new one. (Tighten the Silver Ion Probe in order to avoid
8. Reconnect the electrical connectors of the new Silver Ion Probe,
making sure that the retainer features snap together properly.
Your ECO Mini Purifier is warranted to be free from all defects in
material and workmanship in normal household use for a period of
(1) year from date of purchase.
The warranty is granted only to the original purchaser and members
of his or her immediate household. The warranty is subject to the
following provisions. Any damages or malfunctions caused by
negligence, abuse, or use not in accordance with the Owner’s Manual
are not covered by this warranty. Likewise, any defects or damages
caused by unauthorized service or the use of other than Genuine
Wowtech parts are not covered.
Wowtech will, at its option, repair or replace a defective ECO Mini
Purifier or part(s) for the ECO Mini Purifier that is covered by
this warranty. As a matter of warranty policy, Wowtech will not
refund the customer’s purchase price. Please recorder the following
Warranty Card when you purchase the unit from Wowtech or the
To obtain warranty service you must return the defective ECO Mini
Purifier or ECO Mini Purifier parts along with proof of purchase to
Wowtech or Wowtech Authorized Warranty Station. All transportation
charges on parts, or units, submitted under this Warranty shall be
borne by purchaser. Unless this Warranty is expressly renewed or
extended by Wowtech, any repaired or replaced part of unit shall be
warranted to the original purchaser only for the length of the
unexpired portion of the original warranty.
Please contact us without hesitation if you need help.