In order to ensure hydraulic briquette machine is in good running
quality and hardness mechanical strength of finished briquettes,
special attention to the feeding size better to maintaine below
5mm, preferable size better at 30-40% smaller than 1-2 mm, with no
more than 10% over 5mm. This hydraulic briquette machine design for
12-15% moisture content material briquetting.
Hydraulic briquette machine can be listed into briquette press
machine, dry powder briquette machine, high pressure briquette
machine. Briquette press machine is also called wet briquette
machine, because in molding, material need to add binder and water;
high pressure briquette machine is mainly used in smelting industry
various mineral powder briquetting.
This series of hydraulic briquette machine will pass the power on
to the two pressure roller through the reducer.The two sides roller
runing rotate, natural material goes to briquette hopper, and be
moulded by die holes on each rollers.
When two rollers reach to contact point, the briquetting pressure
goes to top, then briquettes to be squeezed successfully. With the
pressure become smaller and smaller, and briquettes to be off
moulding gradually. Tremendous pressure gives continuously, the
feeding material convert into fresh briquette bit by bit.
Hydraulic briquette machine pressure type is wedge block, spring
disc, hydraulic cylinder, screw compression pressure, etc.
Hydraulic briquette machine regular model is XM290、 XM360 、XM400、
XM500 、XM650 、XM750、 XM850 、XM1000, etc. in which, same model is
further listed into sub-model based on different material and
capacity, like XM750, can be XM750-350、XM750-570. That, 750 is
roller diameter 750mm, 350 and 570 is roller width 350mm and 570mm.
Same model die hole is bigger, capacity is higher. YHG marks dry
powder and high pressure briquette machine.
|Model||Reducer||Ratio||Roller Size(mm)||Main Shaft Speed(r/min)||Matched Power(kw)||Capacity(t/h)||Pressure Type|
|Remarks||1. Above capacity is based on material density 2.0, briquette size
|2. Roller material is 65Mn, High chromium alloy and 9Cr2Mo.|
|3. According to different material, parameter will change slightly.|
The normal package of single set of hydraulic briquette machine is
wooden box (Size: L*W*H). Normally the wooden box is fumigated-free
according to export rules. Spare parts is put into wooden case or
steel box, bigger model loaded in container in nude, or cover with
plastic cloth. We export through Qingdao Port, also can be
nominated by customer. We have superior cargo agent to arrange the
sea shipment for each client, competitive price, secure